Pages

▼

Monday, October 22, 2012

Heart Rate Monitor Project – Phase 1: Software

Over the weekend I developed some initial code to work with the hardware setups posted last week. The code was developed in Arduino 1.0.1.

Ant+ Heart Rate Monitor Code for Arduino

at

4 comments:

  1. Douglas RobertsonJanuary 23, 2013 at 5:00 PM

    Did you get this to work? I am thinking about using the Garmin temp sensor in a project. Where did you get the spec (ANT_DEVICETYPE, etc) for communicating?
    Cheers,
    Doug

    ReplyDelete
  2. digitalhackJanuary 23, 2013 at 8:02 PM


    Douglas,

    I got the heart rate monitor working. I got my information from several sources. The best by far is http://www.thisisant.com.

    If you look under the development section they have information on device profiles.

    digitalhack

    ReplyDelete
  3. RetroRunnerReadoutAugust 21, 2013 at 6:58 AM

    Hi DigitalHack,

    Thanks for work on this. I am looking to do something similar and have taken your code and refactored/reworked and put into a library.

    The lib is at
    https://github.com/brodykenrick/ANTPlus_Arduino.

    The information about the rest of the project is at
    retrorunnerreadout.blogspot.com .
    Cheers,
    Brody

    ReplyDelete
  4. AnonymousApril 4, 2016 at 11:00 PM

    Hi,

    I tried to follow your setup but I am getting this result on my Serial monitor:

    Starting...
    Config Starting
    TX: A4 1 4A 0 EF
    TX: A4 3 42 0 0 0 E5


    Can you please guide me on fixing this one?

    ReplyDelete